Notify me when the price drops
We will email you if we find a lower price on this product!
This listing is for a 3D printed adapter that will thread into the rear port of most Questar telescopes with the 30mm rear axial port and allow 1.25" accessories to be used; eyepieces, barlows, diagonals, cameras, etc. The adapter is printed in strong and durable PETG Carbon Fiber. It includes a metal thumbscrew with brass compression ring to retain the accessory without damaging or marking the item. This will also thread onto the top eyepiece portion if you have a 30mm threaded opening there as well. Please note that most Questars before 1964 had a smaller opening in the back so this adapter won't work on those, please measure to confirm.
Dimensions:
Overall Height: 40.5mm
Flared Width: 42.5mm
Body Width: 38mm
1.25" Internal Depth: 35mm
Threads: M30x0.75mm
Thread depth: 2.5mm
Opening at threads: 26mm
Weight: 26g
*Reminder* - This part is 3d printed and the threads on this adapter are plastic, while they are strong and accurate, it is easier to cross-thread this item and permanently damage the threads than with a metal part. Take great care when threading this on; I like to turn it counterclockwise until you feel it click into the first thread, then rotate clockwise to tighten. If you feel strong resistance, stop immediately and try it again. If it is too tight no matter what, make sure your female threads do not have any gunk, dirt, grease, dust embedded into the threads (my scope did, I was able to clean them out with a small dental tool or a 0.75mm thread pitch gauge).